How to adjust the automatic screw machine? How to adjust the track?

In the production process, the position of the parts will change due to vibration, screw specifications are different, automatic screw machine in the production of a small problem of dissatisfaction.

1. Brush adjustment: After installing the screw into the feeder, turn on the power adjust the brush near the track. Adjust until there is slight contact between the screw the brush

2. Adjust the guide rail through the screw: adjust to the height of the guide rail through the screw slightly higher than the nut 0.1-0.5 mm

3. Sensor adjustment: When the screw is located between the sensor transmitter receiver, the feeder senses the screw, the feeding mechanism turns, the LED lamp lights up; When the screw is sensed, the cloth wheel continues to rotate the LED lamp is off. Observe adjust the height of the sensor (sensor adjustment screw).

4. Adjust the track cloth module (the most critical place): There is a certain gap between the track cloth plate. If the track collides with the cloth plate, the cloth plate will be reversed repeatedly. If the clearance is too large, the screw may get stuck in the initial clearance fall into the machine. If the track comes into contact with the distributor plate, friction will increase the screw will be smoothly delivered even if the vibration increases. Adjustment method: loosen the rail fixed screw (in orbit adjustment holes), push-pull orbit to the appropriate location, a fixed orbit, loosen screw module cloth, fabric module to move up down around the cloth plate does contact with the track, fabric surface flat slightly below the rail surface, orbital exports towards fabrics plate slot, finally fixed fabric module

5. Press plate height adjustment: observe adjust the height of the nut press plate to be slightly higher than the nut by 0.2-0.3 mm. There should be no overlap between the nut nut.

6. Vibration regulation: the supply speed of screw is related to the type vibration of screw. If the speed is satisfactory, it can be adjusted. (Remove the back cover adjust if necessary) Adjustment method: Loosen the vibration adjusting screw (at the back of the machine), turn the vibration adjusting screw (at the bottom of the machine), strengthen clockwise, otherwise weaken; Observe adjust to appropriate feed rate. The guide will collide with the cloth plate, the screw will fall off the gap in front of the guide. Refer to the section on adjusting guide rails. Finally, tighten the vibration setting screw

7. Stop interval adjustment: When the machine senses that there are screws between the sensors, the cloth tray will immediately stop rotating, the main motor will continue to feed for a period of time, then stop running. Adjust the length of time to maintain the consistency of the screw conveyor. Stop interval of rotation adjustment (lengthened clockwise, shortened counterclockwise)