On - line screw machine how to solve the problem?

The problem with in-line screw machines is usually parts electronic components that wear out easily. The rack is a metal part that will be damaged without external gravity. Part consumption is a problem for all machines equipment. On-line screw machine belongs to automatic mechanical equipment. Screw locks are of higher quality standard than conventional locks. There are few quality problems. However, the equipment has a long service life must be replaced maintained.

In particular, the on-line screw machine efficiency is very high, must be replaced in time to waste parts, in order to avoid quality problems. Three components are vulnerable to damage by in-line screwing machines: the electric batch, the nozzle, the air pipe. Attached is the consumables list of a machine we produced before. If there is any problem with the screws in line, please inform the manufacturer immediately consult by phone. If the problem cannot be resolved, the manufacturer may need to arrange technicians to perform on-site maintenance.

In traditional labor-intensive enterprises, such as toys, electronics, plastics, communication equipment, small home appliances, furniture other traditional labor-intensive enterprises, the online screw machine always USES one hand to grasp the screw, the other hand to grasp the screw lock the screw in the batch mouth.

When a hand to make the necessary "grab, mobile, waiting, aim at" to tighten, the time consumed is tighten a third more of the time, especially for the stainless steel copper other screw cannot be adsorption of magnet, consume more time the number of tight stand on each production line is very big. Therefore, for a long time, how to improve the speed of screw lock has been a very difficult problem for grassroots managers, also how to realize the automation of the production line.